Support D-shot 600(default), 300, Oneshot, Multishot.
Switched to efm8bb21 (pin compatible).
Better tabs (you can now solder from the side).
Input Voltage: 1S
Peak Current(10s): 5A
Suitable for BWhoop B05
Mounting Hole: 16x16mm,M2(hole-to-hole spacing)
Support: D-shot600 (default),D-shot 300, Oneshot125 and Multishot
Size (PCB): 20x20 mm
Weight: 1.3g;3.2g(included wire and plug)
1 x 1S 4 IN 1 ESC
4 x Nylon spacer M2*5+5
8 x Nylon Nut M2
4 x Nylon Screw M2*8
All credit goes to tinyFISH FC for the design and illustrations, is under the CERN open hardware license v1.2. If you want more information, pls click :http://fishpepper.de/projects/tinypepper/ (ESC:tinyPEPPER v0.5)
Please note that this board is for 1S operation only. Do not even try 2S, the board will be immediately releasing all it's magic smoke and stop working.
Q1:How to solve one of the problems that cannot connect to BF？
A1: Dear customer, please connect the battery before connect the BF，because B05 flight control is designd by fishpepper，in order to make it smallest and lightest，it reducing the USB power conversion module.
Q2: How to setup the Flight Control USB driver ?
A2: Dear customer, If you can not connect the flight control through the above steps and you can’t see the new COM port, you can try to use these two drive repair tools:
Q5:What kind of remote control can be used in different receiver versions ? A5: Dear customer, the user needs to check the remote control instructions. The instructions will show you whether it supports this receiver mode(such as sbus, ppm, etc) or not, and it will show you how to switch to the receiver's mode.
Q6:How to deal with the abnormal binding?
(Aircraft that binding success but can't use remote control is not included) A6: Dear customer, please refer to the following operation:
1. Measure the voltage between GND and 3V3. If the battery is between 3-5V,
it means that it's not the problem of the flight control power supply.
It might be the problem of the receiver, and the receiver needs to be replaced.
2. If the voltage between GND and 3V3 is below 3V or above 5V, the problem is in the fight control and you need to replace the flight control.
The following is the normal performance of binding:
Q7:After the remote control and receiver is binding successful (receiver light and sound is normal), how to deal with the problem of remote control can't control the aircraft or can't control aircraft after reflash the firmware? A7: Dear customer, in general, it's caused by the incorrect flight control terminal parameter adjustment. You need to adjust it in the corresponding receiver mode of Betaflight. You can refer to the 4 kinds of receivers binding of B06 and BF settings(B06 FAQ Q8-Q13).